In this other aspect of the boat with all the gardens
In this picture we can appreciate the finished gardens.
We will take the ornaments of the comb and the paint, and I painted white.
ramin With a strip of 2 x 3 mm will cut adjusted to fit and arem the arm rests on the balconies giving its curvature the paint and stick with quick-drying glue, and paint the exterior shots of the transom .
arem In the upper windows the same operation as in the windows environment.
Cojeremos 30 wooden columns and balustrade of 10 mm and white paint, once dry the paste will go one by one with fast-drying glue.
With plates of sapelli of 0.5 x 5 mm CTL arem sockets through the windows of the gardens at the stern. with a strip of 2 x 1.5 ramin arem cutting as the top auction windows sockets.
strip cut from sapelli of 2 x 2 mm to measure and will stick upright between the windows, distributed as shown in the picture. This will get get a depth effect in the middle and upper windows of the gardens of the mirror.
strip cut from sapelli of 2 x 2 mm to measure and will stick upright between the windows, distributed as shown photography. with it get get a depth effect in the lower windows of the gardens of the mirror. with a strip of 2 x 8 mm arem the top section of the transom as giving before, if we find difficulty in bending we use strips of 2 x 4 mm.
sapelli with strips of 2 x 5 mm adjust two pieces of ribbon and place it as shown in the photograph shall be placed where the balconies or balustrades, and place the interior finishing top of the comb, the curvatures with plates sapelli arem 0.5 x 5 mm.
sapelli With two strips of 2 x 5 mm arem the exterior and interior shots of the comb and finish lower the latter shall acquire the same curvature as the mirror. Now
blue paint as shown in the picture.
ramin With sheets of 0.5 x 5 mm comb line the stern.
Glue the remaining two sets of windows below the first. The guidelines and distribute as shown in the picture.
painted white, on one side, the three groups of windows of the gardens, and reserve until dry. Apply glue to the areas of contact and will stick the windows shown in the picture behind the mirror comb. We note that the windows must conform to the curvature of it. Present the set of windows in the stern of the boat i will stick and fastened with clips.
Cojeremos windows aft of the gardens. With a cutter will cut the nerves that connect the windows to the plate and separate.
While the comb is taking shape, with sandpaper puliremos grained transom. Then paint the same color blue used for gardens to port and starboard, paint the mirror. the reserves until the paint dries.
Now with the wet comb cojearemos stern with tweezers in a round container such as a round case and a glass jar, to take shape.
Now stern Liares the comb on a wet cloth about eight hours.
In this picture we see the stern and cut comb, and all its contour sanding with sandpaper fine grain.
With a scroll saw will cut the whole environment of the comb at the stern.
In a 4-mm plywood, trace the stern comb. Http://211060.guetbook.motigo.com