Inurl:multicameraframe Mode

The belfry railing bell and figurehead

In this picture you can see the look of the boat once this phase of the assembly. Reserve remaining materials for use in subsequent assembly stages. is very likely that we use the length of the rubbing bands to strengthen the stem so that the mask comes into place. Once the necessary checks and adjustments, we will place the mask, apply fast-drying glue on the stem joints. As we can see, the mask is designed to hold her legs the end of the stem. Will place the mask in the stem without glue, to verify that it fits correctly, as shown in the picture. We the two remaining teams well focused and stick to the pillars of the mizzen cabillero. In the picture we see that are stuck in the stern of cabillero. Cojeremos metal chimney and painted black. Apply glue to stick the base and centered between the two teams focusing its opening bell to bow, as shown in the picture. recovered the iron of the remaining squares, using a cutter, we extract four squads of sandpaper puliremos fine-grained and red paint. Apply glue and will post two teams focused against the pillars of the tower, as shown in the picture. rails to build the railing of the tower, sapelli cojeremos a strip of 2 x 4 mm. Cut two pieces of 25 mm in length. Lijaremos both battens and painted the same red paste columns and columns focused on touching the bell, as shown in the picture. Now the bell will stick in front of the opening frame of the main deck focused. We will take four columns 10 mm in length and red paint. Apply glue on the base and, with tweezers, glue the four columns distributed as shown in the picture. will paint the hood black, the hood has a through hole in the center. Insert the end of the eyebolt to the hole and slide the hood up until it stops with the ring of the eyebolt. Then apply a little glue on the joining of two pieces, and adjust the length of the eyebolt is visible at the bottom of the bell with the help of cutting pliers. Leave to protrude slightly below the edge of the hood. Cojeremos the belfry and red paint. With the help of pliers, the ring will open an eyebolt, push the end of the ring through the hole in the center of the bell tower and close the ring again. Apply a little glue on the joining of two pieces.

http://211060.guetbook.motigo.com