Make fife rail and place the rods sapelli
with strips of 2 x 4 mm, we were going to build cabillero of the bands of the boat. We mark with a pencil twelve pieces of 25 mm in length on each strip. Then, with a punch, distribute eight holes in each of the pieces.
opened the holes with a drill and a drill of 1.5 mm in diameter, the same distribution as in the previous step. Then cut the pieces and, with a fine grit sandpaper, go over the outlines.
apply fast-drying glue three cabillero look at the bow of the hull. The cabillero must be pasted below gives caps and the holes for the rods should be visible.
cabillero We hit three more in the stern of the hull, distributed as shown in the picture. Remember that we attach the same amount of cabillero on the other side of the helmet.
then begin to put the rods, one in each hole in the fife rail.
This boat will look like once placed the fife rail and rods. Reserbamos remaining materials for use in stages of assembly backs.
0 comments:
Post a Comment