How To Build A Concrete Raised Pond

Make carriages and cannons mounted the fourth battery.

In this other picture you can see all the guns of the cover and finished with all intrigue.

In this photograph you can see the maneuvers of the guns on both sides of the boat

This photograph shows the guns ogserbar their gear and mounted.

with blocks of 2 mm and 0.15 mm raw thread, do the pulley rig the canyon.

apply some glue under the wheels of a cannon carriages and look forward focused each pocket of the 4 th battery. We should only set the carriages, and the ends of the wires should be free. Later, we will complete the setting of canyons. panties To set back to the bulwarks, using eyebolts. We conducted a blind hole of 0.8 mm in diameter on each side of the guns, as shown in the picture. We will be careful not to cross the rail. To make the pants back of the canyon, we take a piece of brown wire of 0.25 mm thick, and cut a piece of wire about 150 mm in length. We conducted a simple knot that embraces the rattle of the cannon, as shown in photography, and set the knot with some glue. Perform the same operations with the other 27 guns. In this picture we can see the carriage and mounted with the barrel and wheels. With a strip of 2 x 4 mm cut off the bases of the carriages, cut 28 pieces to 16 mm in length each, and will stick to the sides with a ratio of 2 sides of a base, and paint. In this picture we can see the sides of the carriages already failing as the finishing touch with a limatón plane. ramin With a strip of 2 x 6 mm going to do the side the carriages, cut 56 pieces to 16 mm in length and give the shape of the carriage.

http://211060.guetbook.motigo.com