In the stern deck of the poop, we will open four holes aligned as shown in the picture. Then we set a pulley block and three strap lugs. Perform the same operation on the other side of the hull. About 
layer fogonadura the mizzen (in the back of the helmet), drilled six holes distributed as shown in the picture. After four slings look pulley block and two eyebolts with quick-drying glue. 
side next to the hole for the mast (the middle of the cover), will open the necessary holes and set five straps of pulley block and three lugs. 
pulley block strops will post five and three lugs with glue distributed as shown in the picture. 
With a drill and a drill of 0.75 mm in diameter, drilled eight holes in the sides of the bottom layer of the ratchet fogonadura, as shown in the picture. Remember that the stick is the ratchet is located in the front of the main housing. 
cojemos a pulley block are the pieces that have two holes. Put it on the wire so that its holes coincide in the same direction as the ring of the eyebolt. We will make another overhand knot so that the thread embraces the pulley block. The line tight so that the piece is secure. Apply glue to prevent the knots loose. Then cut the excess single thread block. 
Cojeremos crude thread diameter of 0.15 mm and an eyebolt for the straps of pulley block, cut a piece of wire about 100 mm in length. Insert one end of thread into the ring of the eyebolt. We will make a simple knot distributing the excess wire as shown in the picture. http://211060.guetbook.motigo.com 
0 comments:
Post a Comment